Raspberry Pi 5 Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Raspberry Pi case with Hat hole for breakout board
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 67
- Makes
- 0
- Views
- 999
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
Raspberry Pi 5 case. I got a breakout board from amazon (Freenove Breakout Board for Raspberry Pi 5 / 4B / 3B+ / 3B / 3A+ / 2B / 1B+ / 1A+ / Zero W/Zero, Terminal Block HAT, GPIO Status LED : Amazon.com.au: Computers) but because i had the active cooler on there it would not fit without shorting out the pins on the cooler heatsink. So i got a GPIO riser from jaycar (Stackable Header for Raspberry Pi | Jaycar Electronics). Then built this case to house it.
I printed the top part with no top or bottom layers with 50% infill to give a mesh air vent. I also increased the walls to 3 to ensure the screw holes were still secure.
The feet I made 3 options, Self tapping screw and washer on top or just pop into holes by themselves as in the picture. Hex nut underneath for a screw and washer on top, lastly single screw hole all the way through for fixing it to a surface. I printed them in TPU.