1 / 4
Peopoly Magneto X Enclosure Screen Backer
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This fits behind the screen of the Magneto X so that when the top enclosure door is closed the gaps are minimized.
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 56
- Makes
- 1
- Views
- 342
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Update: I have added a version where the notch for the cable has it's opening against the printers frame instead of the enclosure top. This should prevent the cables from getting in the way of the enclosure top if you remove it for maintenance and attempt to replace it.
Print with strong tree supports, .2mm layer height. No additional hardware is needed.
To install:
- Power off printer
- Unplug screen
- Loosen bolts to screen until they are no longer protruding through the screens metal frame, but are still attached.
- Slide the backer behind the screen so that the angled pieces on the bottom slide into the screens metal frame, they are the same width so make sure the are lined up. When in the correct position, the right side of the backer will be against the frame. Also make sure your cords are going through the notch in the corner.
- Hold the backer so that it is flat against the top of the printer body, and tighten the bolts. The bolts will align with the holes in the backer if you aligned it correctly.
- Tighten bolts back up and check fitment with the door.