1 / 2
2014 Ram 1500 Carpuride W903 Dash Bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I wanted a clean mounting solution for my truck so I made it.
- Rating
- 0 / 5
- Likes
- 22
- Downloads
- 99
- Makes
- 0
- Views
- 1,625
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Share Alike
It's split into two pieces so it can be printed without supports. You will need three m3 heat set inserts along with three short m3 screws for mounting the top half. Screw the bracket part in with two #6 coarse threaded screws into the two holes left after pulling out the two screws under the rubber dish (top of the trim piece). Print it out of something heat resistant and I used pretty high infill percentage, but your mileage may vary.