Radxa SATA HAT Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case for the Radxa SATA HAT
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 175
- Makes
- 0
- Views
- 2,716
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- GNU General Public License v3.0
I wanted a case to hold my Radxa SATA HAT and drives securely and without just leaving them to get knocked over. This is a quick and dirty answer to that. It doesn't have an opening for the eSATA port, and the power ports could be a little cleaner, but it's nicely ventilated. In heavy use with a 40mm fan pushing air into the case, the drives stay below 40C, and the Pi runs at 45C.
You will need M2.5 hardware to mount the Raspberry Pi to the base of the case and the brass standoffs that Radxa provides, and the top was designed to be attached with M3 hardware, but I suspect M2.5 would work as well if you have it. The OpenSCAD design is included and uses parametric nuts and screw definitions, so it should be fairly flexible. I ultimately used heat-set M3 nuts in place of the nut catches that are designed into the case, but in practice the case should work with common M3 bolts and nuts.
I designed it to be 3 perimeters of a 0.4mm nozzle, but it should be parametric enough to be adjustable to your needs.
I printed some feet in TPU because I ran out of self-adhesive rubber feet, and there's a sort of an attempt at a drive cage to make sure the drives are supported by the frame of the case and not just the SATA headers on the board.
The current height of the top will accept a 20mm tall 40mm fan if you use standard fan screws from the outside. There's very little clearance on the inside, if you were thinking about using machine screws & nuts, you should stick to 10mm tall fans, or edit the “CaseTopZ” parameter in the .scad and export a new STL.
A Noctua 4020 5v PWM fan in non-PWM mode does a good job of cooling without being too loud - at idle the drives are only 1-2C over ambient and the CPU is down at 35C. At full tilt, the drives only heat up another few degrees, but the CPU is cooling limited and will hit 60C.