beefy power supply for raspberry pi
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A better power supply so Klipper would stop complaining about throttling. Print both parts with the flat face down and…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 20
- Makes
- 0
- Views
- 207
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A better power supply so Klipper would stop complaining about throttling.
Print both parts with the flat face down and enable supports on buildplate only so the two screw holes can print without issue. Any filament material should work. Tolerances are quite large so the case should come together quite nicely. The converter brick should be inserted corner first so one mounting pin can pass through one mounting ear; you won't be able to insert it all at once due to the retaining lip in the back. Find a long, > 20mm M3 screw, your regular sets of up to M3x16 are way too short. I am providing the FreeCAD design in case modifications are needed. Please observe the license terms.
Non printed parts:
- Power converter 12/24V 75W to 5V 15A https://a.co/d/jey2ZED
- Female PCB mount USB-A socket connector https://a.co/d/eOQEOiE
- 2 pin PCB mount block connector https://a.co/d/1YXFSJH
- DC 5.5mm female barrel jack to block connector adapter https://a.co/d/f1iUokh
- 12V DC 24W power supply https://a.co/d/gpDbsLo
- small piece of double sided prototype PCB board https://a.co/d/ar1fBAK
- M3 nut and M3 screw
- solder and flux
- multi stranded lamp cord wiring or thick single stranded copper insulated wire
Category: Electronics