Eighth inch endmill holder - gridfinity - vase mode
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This two piece print designed for vase mode holds up to 15 endmills with an 1/8th inch shank in a grifinity grid.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 23
- Makes
- 1
- Views
- 151
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
This part is made in two pieces that nest. Print each piece in vase mode (0.4mm nozzle, is what I used), then slide them easily together. And you can store up to 15 endmills, 1/8in. shank, neatly in one #gridfinity square.
The trick is printing the base/outside piece right side up, and printing the insert/endmill holder upside-down. Set your slicer for vase mode, and print them one at a time with a 0.4mm nozzle, and they should slide easily together.
The trick to designing such a part is making sure that there is only one path around the whole thing, that's why the side lines are cut in. Also, at the bottom of each hole is a slant which allows for minimal stringing as the hole tapers to a single straight edge.
