1 / 2
Magnetic Stir Base
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Magnetic Stir Base that is based around the GBM4008-150T motor.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 8
- Makes
- 0
- Views
- 113
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
A Magnetic Stir Base that is based around the GBM4008-150T motor.
Need the following:
- GBM4008-150T motor. (use included screws)
- 2x 14mm diameter be 10 mm magnets.
- A half size 6 inch deep steam pan.
- A speed controller such as https://www.amazon.com/gp/product/B09PV3R3JQ/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1
- A 24 volt power supply with at least 1 Amp of current.
- A magnetic stir / impeller such as this one by rsilvers:
https://www.printables.com/model/207888-magnetic-stirrer-impeller
Instructions:
- Print out of clear PETG.
- Epoxy the magnets into the MotorMagnetAdapter and wait 24 hours.
- Screw the MotorMagnetAdapter to the motor.
- Hot glue the MotorMagnetCap over the MotorMagnetAdapter.
- Screw the Motor into the MagneticStirBase making sure the wires go out the wire channel.
- Wire the motor to the Speed Controller.
- Wire the Speed Controller to the power supply.
- Plug in the power supply.
- Place steam pan on top of base.
- Slowly turn on the magnetic stir to get magnetic stir up to desired speed.