Neptune 4 Hotend 2mm IDC Connector Strain Relief (Plug, Clip)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Strain relief for 2mm IDC connector located on Neptune 4 / Pro / Plus / Max hotend. Possibly applicable to other models.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 20
- Makes
- 0
- Views
- 440
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
I couldn't find a model for the 2mm IDC connector strain relief as used with Neptune 4 Plus hotend assembly, so I created this one measured from the broken pieces I had on hand. May fit other 2mm IDC connectors.
Print with a well tuned printer. Model is oriented upside-down of typical printing orientation. Flip 180 degrees in the slicer. No supports needed. When slicing, make sure gaps are well filled. 3 walls, arachne generator, precise walls worked for me.
I printed successfully with Polymaker PLA Pro on a Bambu A1 mini.
Fits well, but is delicate and very snug fit during insertion, so take your time. Is secure after installation. If you're worried about your ability to print the small tabs, you can do without them by breaking them off or not printing them. If using this with a Neptune printer, the hotend assembly connector is captive and will hold the IDC connector in place even without the locking tabs.
Only tested with Neptune 4 Plus (pictured, 24-pin connector; this connector is also used on Neptune 4 Max). I've included a file for the 20-pin Neptune 4 or Neptune 4 Pro, but haven't tested it. If you need this for a different 2mm IDC connector, you can use OpenScad and the .scad file to generate an .STL for the width you need, or send me a message and I can upload one.