Simple mouse BL Kit002 (One part only- PrintinPlace)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mouse that can be easily printed in one piece with smooth curves and surfaces.
- Rating
- 4 / 5
- Likes
- 51
- Downloads
- 107
- Makes
- 1
- Views
- 1,022
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A mouse that can be easily printed as a single part, the orientations are optimized for smooth curves and surfaces. The electronics are plugged in and held by latches, the lid can be opened and closed. This model consumes just 65g pla. No screws are needed.
Before the part is ready for use, its very important to remove the support on the bottom, otherwise the lid will break off :
Grasp the lid close to the axle and break the movement free while gently move forward and backward, this should not require much force but can take a minute.
It has to be very tight to give it hold while printing and also to maintain the position later when you use it, so be aware to calibrate your filament well. Let me know if you encounter issues.
After the lid moves, you are fine to fit the electronics and the battery, glue the gliders on the underside so that the mouse rests well and you are done :)
No additional support is required. If you were using a bedslinger, position the mouse horizontally to the bed movement and activate tree-support (only from the bed) to prevent vibrations.