1 / 4
Ryobi 18V dual QC3.0 USB Charger — image 1
1 / 4

Ryobi 18V dual QC3.0 USB Charger

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I remixed Sunookitsune's Ryobi DC power jack to instead provide two independent USB QuickCharge 3.0 ports. I printed…

Rating
0 / 5
Likes
5
Downloads
24
Makes
0
Views
246
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

I remixed Sunookitsune's Ryobi DC power jack to instead provide two independent USB QuickCharge 3.0 ports.

I printed them in ABS and PETG. They both worked fine.

What you need to complete the work

Look at the battery to determine polarity. Install the insert part on the battery, then choose which clip is positive. The boards are also marked. Wire the three positives together. Wire the three negatives together. Install the wires in the component side of the board and trim the other side close to the board.

During physical assembly, it helps to plug a usb cable into one of the two boards so that you can keep the two apart while you install the insert.

You need full supports on the "cover" because of the USB board supports inside.

You need full supports on the "base" to support the battery snap clips.

No support needed on the insert

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

Yes

Notes:

ABS and PETG worked fine. It won't be a waste to autogenerate supports everywhere.

Post-Printing

Category: Electronics

Tags