Cap stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cap stand with adjustable angle and height. Adjust the visor using a slider and screw. Supports two heights: 20/30 cm.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 43
- Makes
- 0
- Views
- 433
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Cap stand with adjustable angle of inclination of the cap and adjustable height. The slope of the visor can be adjusted using a slider and a screw. At the same time, you can set the height of the cap. Currently, 2 heights are supported, so that either you do not use the central part and the peak will be approximately 20 cm above the ground, or you use it and it will be another 10 cm higher. Alternatively, you can print an otherwise large central part, the diameter is 15 mm, the center has an 8 mm thread with a length of 16 mm.
I recommend printing with PETG because of the threads.
The stand keeps the balance, but if you have a problem, you can stick the stand to the surface with e.g. double-sided tape or glue.
Enjoy your caps as decoration!