4x5 Back for Polaroid Pathfinder 120 and Polaroid Land 800
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A full frame 4x5 back for old Polaroid instant cameras
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 95
- Makes
- 0
- Views
- 1,507
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Inspired by the great work of Morten Kolve I've tried to design a 4x5 back for Polaroid that was able to cover (more or less) the whole negative.
THIS IS A DESTRUCTIVE CONVERSION PROCEED ONLY IF SURE.
To prepare the camera use Kolve instruction but stop at page 7 (no need to remove rivets either), you will also need:
- 6 m3 heat insert 4-5 mm
- 6 m4 heat insert 4-5 mm
- 2 m2 allen bolt screw 10-12mm
- 8 m3 allen bolt screw 10-12 mm
- 6 m4 allen bolt screw 10-12 mm
- 4 spring 8-10 mm in length and with a diameter greater than 3mm but smaller than 5
- 2.5mm adesive light seal
To fix the handle in place you can use the same rod removed from the left side, but since tolerance it's pretty tight you may need to get a smaller diameter.
You need 4 m4 insert and 2 m3 insert for the base, location is pretty obvious, the m4 are for the slot around the frame and the m3 are for the slot on the right side above the lock mechanism for the back. After you've added the insert remember to glue the light seal in the groove around the frame.
Mount the handle to the holes in the camera with the 2 m2 and 2 m3 screws, then then the chassis holder with 4 m4 and 2 m3 screw.
Add the insert to the chassis holder like so

The m3 are for the top and m4 for the bottom, add the plate and insert the bolts and the springs like so

you don't need springs for the bottom plate.
Check if the screws are tight enough to hold the chassis but loose enough to remove it with a small push upward.
Follow Kolve instruction again to adjust the focus of the camera, for 120 and 800 models the correct stop is Pola110_7_Lens_inf_stop__Universal-text.stl you can find it here.
Obviously you will also need ground glass and any frame to hold it, I suggest to use the one in the project linked above because it's perfectly accurate.
This mod makes focusing and composing a little awkward but it's still 100% possible, just be careful to not hurt yourself while you do so (not joking).
You can print the whole thing in PLA, but I suggest to use PETG or PLA + for the base, since it locks to the camera anche may need a little bit of extra strength.
The mod is compatible with 120 and Land 800 camera but should be fine, or just need minimal modification, also for Land 800 and 100-110 series.
Buona luce!