BIQU Microprobe mount for Elegoo Neptune 4 Max
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
for converting the original inductive sensor to a BIQU Microprobe BL Touch
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 104
- Makes
- 1
- Views
- 1,841
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Btt Microprobe V2 to ZNP K1 V2.0
a Dupont connector with 10K Ohm resistor as pullup for Z- end stop,
yellow from the servo goes to sensor from level PA11,
red+ and black- from the servo somewhere to x/y end stop,
white PC3 and ground to Z- end stop with the self-made pullup
Klipper printer.cfg:
[gcode_macro PROBE_DOWN]
gcode:
SET_PIN PIN=probe_enable VALUE=1
[gcode_macro PROBE_UP]
gcode:
SET_PIN PIN=probe_enable VALUE=0
[output_pin probe_enable]
pin: PA11 # Set to the control pin on your board yellow Cable
value: 0
[probe]
pin: ^!PC3 # NOTE FOR V2 users: Set this to ^! to set the low level trigger white Cable on Z- with 10k Ohm Resistor
deactivate_on_each_sample: True
x_offset: -38
y_offset: 25
#z_offset: 5 # Will be overridden when you do a PROBE_CALIBRATE
samples: 3
samples_result: average
sample_retract_dist: 6
samples_tolerance: 0.05
samples_tolerance_retries: 3
activate_gcode:
PROBE_DOWN
G4 P500
deactivate_gcode:
PROBE_UP
[bed_mesh]
speed:150
horizontal_move_z:10
mesh_min: 25,50
mesh_max: 370,390
probe_count: 11, 11
algorithm: bicubic
mesh_pps: 2, 2
fade_start: 1.0
fade_end: 10.0