Quilter Superblock Amplifier Case and Floorplate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hardcase and floorplate for Quilter Superblock UK and US amplifier.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 22
- Makes
- 0
- Views
- 172
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hardcase and floorplate for Quilter Superblock UK and US amplifier. I made this because I didn't want to put it on my pedalboard and needed a way to safely store it in my backpack. The floorplate can also be used as a base or pad.
Files:
There are 3 files: 1 floorplate and 2 cases for the Quilter Superblock UK and US amplifier. The cases have labels indicating "Quilter Superblock UK" and "Quilter Superblock US".
Printing the Floorplate:
I printed it with PLA at 200°C nozzle temperature and 50°C bed temperature. Printing speed was 50mm/s. You can increase the speed up to 3x the initial speed. I started with 50mm/s for the first layer, then increased the nozzle temperature to 220°C and the printing speed to 300%.
Printing the Case:
I recommend rotating the model so it prints from the top. I used normal support with 20% infill. For the first 10 layers, I recommend using only 100% printing speed.
Results:
The floorplate should fit snugly to the amplifier. The case may be a bit loose, but you can adjust it with warm water. Press the sides of the case while running hot water over it, then keep holding it . To keep the adjustment, hold the sides of the case while running cold water over it.