Multiboom arm attachment for Creative Pebble V3 Minimalistic MF1700
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a mount that is compatible with Multiboard and the Multiboom system.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 30
- Makes
- 1
- Views
- 1,270
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
This requires drilling the bottom of the speaker, using a 5mm heat insert, and then mounting through the provided hole with the mount.
The hole I have drilled is centered on the speaker, and measured from the center of the heat insert is ~30mm from the front.
I made sure to leave a ~5mm gap between the bracket and the speaker so the wires could be moved from one side to the other.
This was done on with the Pebble V3 Minimalist speakers.
The “main” speaker .. the one with the controls and wires .. has a switch that you have to be careful to not drill into.
I advise that you disassemble the speaker to verify placement of hole. You could potentially move the hole forward 5mm on center, but pre-print the bracket to verify that it will fit.
This was printed in PLA, 20%, with three walls.