1 / 1
Glider Ornament
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A ornament of a double seater glider in scale 1:100.
- Rating
- 4.857 / 5
- Likes
- 64
- Downloads
- 697
- Makes
- 8
- Views
- 3,228
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution
The glider prints in two halfs, that way you dont need supports.
For print settings I used the standard 0.1mm profile and increased support to 25%. That way the balance front to back is pretty spot on. You will probably also want to turn down/off the Elefantfoot compensation, so there is no gap down the middle.
For assambly there are two holes in each part, where you can stick in a pieces of filament (about 5mm long) for alignment.
The original glider is a Twin Astir Trainer and I used a scale of 1:100