Strapable Rugged AirTag Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a Strapable Rugged AirTag Case in two versions to support 20mm and 25 mm straps.
- Rating
- 5 / 5
- Likes
- 53
- Downloads
- 156
- Makes
- 3
- Views
- 873
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
This is a new version of the popular rugged Apple AirTag case. It is meant to be strapped onto backpacking, hiking, and urban gear. This version has Backpack Strapable Tops for 20mm and 25 mm webbing straps.
It is designed to either use the included printed seal gasket, or to purchasable o-rings gaskets.
3D Printed Gasket Seal: NinjaTek's NinjaFlex TPU
Orderable O-Ring Gaskets: Nitrile Rubber O-Rings, 39mm OD, 35mm ID, 2mm Width
The case was designed with Ingress Protection (IP) in mind, and probably rates at IP65. Note: If you submerge it in water, you can see tiny bubbles appear since 3D printing typically does not yield waterproof layers.
Note:
The AirTag is a perfect tight fit by design. If you need to remove the AirTag, there is a litte slot inside to insert a pin to pop it out.
Updates:
- 2024.06.24: Added Backpack Strapable Tops for 20mm and 25 mm straps
Also see the original: