1 / 4
SilverStone ALTA G1M JBOD backpack + general purpose JBOD shelf
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
JBOD case for 4*3.5" disks that nicely hangs off the side off a SilverStone ALTA case, also as stand-alone version.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 24
- Makes
- 0
- Views
- 541
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
A custom-designed 3D printable JBOD case, perfectly tailored for the SilverStone ALTA series! This sleek and efficient case is designed to accommodate four 3.5" hard drives, providing a stylish and practical storage solution that seamlessly integrates with your SilverStone ALTA case.
For those that do need to place this on their desk, there's a version with legs to provide fan clearance.
Key Features:
- Perfect Fit: Designed to hang off the side of your SilverStone ALTA case, ensuring a secure and space-saving setup.
- Optimized Cooling: Features bottom ventilation with a 12cm fan to ensure adequate airflow, keeping your drives cool and enhancing their longevity.
- Sturdy Design: Very rigid with 20% infill.
- Easy Assembly: Dovetail joins the two halves. No additional hardware is required for mounting. For the fan, I used a Noctua 5V USB powered fan. But any 120mm fan will fit.
- Cable Management: Cables feed out top and right over to external SAS controller. The case leaves some space to feed out power cables form the internal power supply.
Print Settings:
- Material: PLA, PETG, or ABS (depending on your preference and environmental conditions)
- Layer Height: 0.2mm or lower to avoid supports.
- Infill: 20% for strength without excessive material use
- Supports: Print without supports