Laser center finder for Dremel press by pejvl2000
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adds laser center finder to make accurate PCB drilling easier.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 24
- Makes
- 0
- Views
- 194
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
I love the Dremel drill press by pejvl2000 https://www.printables.com/model/308219-dremel-drill-press but I needed a center finder to assist my aging eyes and hands.
This model uses two 5mW line lasers I got from Amazon: https://www.amazon.ca/gp/product/B0842HPB44
I remixed these two models: https://www.printables.com/model/370429-generic-lockable-ball-joint by https://www.printables.com/@HD_Creator and https://www.thingiverse.com/thing:6455549 2032 battery holder by mintonette.
The former was modified to support laser turrets by attaching a ball socket directly to the Dremel holder, using a couple of small screws and CA glue. The latter was enlarged, to accommodate a 3X2 dual pin header for plugging in lasers (using 2-pin Dupont female connectors) and a small jumper that acts as a switch.
The objective lens of the laser provides both focusing and alignment. Both need to be changed when you change the drill bit. To avoid realignment, I could have attached the lasers to the drill press' column instead of to the Dremel holder, however, I prefer the light beams to cross at the right(ish) angle.
When printing the turret, please rotate the object so that the threaded part is touching the bed, it can be then printed without supports.