Wall Bracket for Power Strip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Wall Bracket for different types of power strips. Fix the bracket on the wall, place the power strip in it, ready.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 182
- Makes
- 0
- Views
- 719
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Do you know “Flying” power strips because the cords are too short or clutter on the floor. With this easy to print wall bracket you have a better "home" for a power strip.
Fix it with two or four screws on the wall and place a suitable power strip temporarly in it. I have tested it with different German types of power strips but not all will fit. The bracket is fine for a power strip with a height of 42 mm and a width of 44 mm. I will design a bigger bracket later on.
Wenn using the bracket, make sure that the plug or power supply is still unobstructed in the power strip, when this is not possible, don´t use this model of wall bracket and design your own. When use a part for electrical devices please note your local code.
If have printed the bracket with PLA. The bracket needs support in two areas, the overhang there is to big. Please have a look at the attached picture (screenshot PRUSA slicer).
For the design I have used Fusion 360 and the Prusa slicer.