1 / 3
Fractal R5 PSU Shroud
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A power supply shroud for the Fractal Design R5 (or most mid-tower cases). Includes a mounting point for a 120/140mm fan
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 96
- Makes
- 0
- Views
- 734
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
Features
- A decorative power supply shroud for the Fractal Design R5, but will likely fit several mid-tower-sized cases with removable hard drive trays
- 410mm long, 94mm tall, 170mm wide
- Includes a 120/140mm fan mount for GPU cooling, cutouts for cable routing, and a sloped design for better front airflow
Printing Guidelines
- Layer height: 0.2/0.3mm
Supports: No
Brim: Yes (front, mid, rear), No (fangrille)
Walls: 2+
Infill: 10%+
I suggest printing everything in the orientation the model comes in, to prevent excessive overhangs or build plate artifacts from being visible.
Assembly
- Remove all brims and glue the rear, mid, and front together - the rear and mid slide together neatly, then the front presses on afterwards.
- Once set, glue the fan grille on. This may be a tight fit, so you might need to sand the edges down slightly.
- Install a fan (if you want), remove the Fractal's bottom HDD cage (you can keep the top one) then slip the whole assembly into your case - the very rear of the shroud should slip between the PSU and the PCI-E slots.
- Cable route as needed, and you're done.