Hard bait lure box

This is a hard bait storage container that can be used on both sides.
 

• It can store metal jigs, minnows, egi, etc. that are less than 100mm long.
  There are five compartments on each side.

• Each part requires some support due to protrusions, etc.
  Please set it by referring to the following picture.

• The interior of the body parts does not require any support.
  Set the threshold angle of the support setting to a low value, such as 10 degrees, to prevent internal support from occurring.

• The recommended material is PETG.
  It's okay if it's not transparent.
  I am not familiar with 3D printing, so it was difficult to print transparently.
  However, it seems to be okay because it prints at a slow speed.