1 / 8
Organiser for electronic parts
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Box - organizer for basic electronics (display, jumper wire, resistors, transistors, LED diod, etc)
- Rating
- 4 / 5
- Likes
- 4
- Downloads
- 54
- Makes
- 1
- Views
- 330
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The organiser consists of two parts printed separately. I would recommend printing the top part with clear filament as I think it will look good.
The dimensions are 18,9 cm wide, 14,4 cm high and 3,2 cm deep.
I recommend printing the bottom box in PLA and the top box in PETG.
My print setting:
- Printer brand:
- Prusa
- Printer:
- MK4
- Supports:
- Organic (but maybe they are not needed it was my first print)
- Resolution:
- 0.15 (Input Shaper) (maybe you can run it faster and on speed mode)
- Infill:
- 15%
- Notes:
- I've changed the upper part of the box a bit since I last 3D printed it, I've put in a bit more clearance for rotation and I've also enlarged the brackets so it doesn't move around and has better stability.
- Also, the last time I 3D printed it, I had to sand down a little bit both the brackets that hold it to the box and the ones on the box because it wasn't perfectly round and it was jamming and ruining the case.