1 / 2
MP5 Curved Airsoft Magazine (fits Mosquito) — image 1
1 / 2

MP5 Curved Airsoft Magazine (fits Mosquito)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Curved MP5 airsoft midcap magazine that fits the Mosquito. Quick print, easy assembly. Beta, testers welcome. STEP files

Rating
5 / 5
Likes
141
Downloads
780
Makes
2
Views
4,654
Reviews
3

Updated at source:

Model information

Category
Outdoor Toys
License
Creative Commons — Attribution — Noncommercial — Share Alike

INTRODUCTION

I couldn't find a nice curved (and free) MP5 magazine for my Mosquito so I created my own. Feel free to try it out and complain if you have issues.

STEP files now available.

The model is based on two existing models:
- BB channel geometry based on “AR15 airsoft magazine (midcap)" by Igniz (thingiverse link)
- external geometry based on “MP5 mag Cyma” by Konstav (cults3d link)

 

BILL OF MATERIALS

Printed parts:

  • 1x left magazine half
  • 1x right magazine half
  • 1x BB holder
  • 1x Feed spring holder
  • 1x Universal 3D printed midcap follower (model by Igniz) - Download on thingiverse

Non-printed parts:

  • 1x pen spring (⅓ or ½ is enough)
  • 1x BBs feeding spring 600-650mm (from a spare M4 airsoft magazine)
    • v1 (hollow model) actually needs a 300-320mm spring so you can make two MP5 mags out of one M4 spring - or leave the spare length hanging outside during testing - see pics
  • 2x M3 bolts ~20mm length
  • 2x M3 nuts
  • 1xM3 or M4 bolt or pin to keep the spring holder in place


PRINTING MAGAZINE HALVES
 

SUPPORTS

Add support in 2 spots:

Note: DON'T add supports on the M3 holes, they are designed to be 1 layer thick so you can punch them out with the M3 bolts

 

LAYER HEIGHT

Very important to set these correctly! Otherwise the designed geometry will be distorted when printed and your BBs will get stuck (the magazine won't feed well).

0.4mm nozzle diameter:



Play around with the layer heights at your own risk.

 

PRINTING BB AND SPRING HOLDERS

No specific instructions here, just add supports where it's logical.


GENERAL PRINTING DETAILS

  • 2 perimeters are enough
  • 0.5 mm extrusion width (default in PrusaSlicer?)
  • Top/Bottom layers - 0.5mm, 2 layers is enough
  • I printed in generic PLA, feel free to try other polymers

 

ASSEMBLY

  1. Check if the pen spring fits the BB holder part. If not make them fit
  2. Cut a length of the pen spring - 15mm should be more than enough
  3. Get the 2 mag halves and punch the M3 holes through - you can use the M3 bolts for this
  4. Carefully assemble the pen spring and two mag halves together
  5. Tighten with M3 bolts/nuts
  6. Attach the BB spring to the BB follower and route it through the hole
  7. Add the BB spring holder and fasten it to the mag with the 3rd bolt
  8. Voila.

 

KNOWN ISSUES

The BB spring holder is a bit fiddly and can get stuck inside the mag channel. I'm working on a V2 ATM.

I'll add complete .3MF files so you don't have to fiddle with settings.

Better promo pictures.

Tags