Bomb keychain. Satisfying. No glue assembly.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cute little key chain, shaped like a bomb.
- Rating
- 0 / 5
- Likes
- 22
- Downloads
- 54
- Makes
- 0
- Views
- 388
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
The base concept for this model is to have a key chain that can be assembled without glue so parts can be replaced if needs be.
SETTINGS :
- 0.1 layer height
- 3 walls
- 5 per cent infill
- Supports ONLY for the half spheres. (I used tree supports)
Print everything and get a small chain.
What I'll call "pins" during the steps bellow, are pieces of filament.
The FLAME model needs a color change so that the part can end up being yellow and red.
The FLAME model is derived from this flame model
ASSEMBLY :
- Step 1.
Insert the WICK in the TOP HALF SPHERE. Insert a 5 to 6 mm pin in the hole of the WICK with tweezers. Try your best, it'll work eventually !
- Step 2.
Insert the WICK into the FLAME and lock it in place with a 10mm pin.
- Step 3.
Insert the chain in the rectangular hole of the BOLT and lock it in place with a pin, 11mm in length max, and make sure that it doesn't clash with the threads.
- Step 4.
Screw the BOLT in the TOP HALF SPHERE, until it's tight.
- Step 5.
Thread the chain through the hole in the BOTTOM HALF SPHERE and screw the BOTTOM HALF SPHERE until it sits tight against the TOP HALF SPHERE.
Enjoy !
Please post your makes !