Garage door remote clip

I purchased a garage door opener and the 2 remotes only came with 1 clip.  I could buy another clip, but where's the fun in that?

I printed this clip to fit over the 3mm thick side in my glove box.  I used Inland Nylon to resist the heat in the car.  The spine ridge also helps reduce deformation.

This was printed on my MK4 with a 0.4mm nozzle.  0.15mm layer height with 3 perimeters.  I placed the model on it's side so the clip would have strength, and painted-on supports where the flange and end hook float above the build plate.