Clamp for Thule Tour Rack
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clamp for Thule Tour Rack to attach lamps, reflectors and alike.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 12
- Makes
- 0
- Views
- 154
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
I upgraded my bike with the Thule Tour Rack, unfortunately I had to move my back light and my back reflector to another place, due to space issues.
Therefore I created these simple clamps, to which i attached the lamp and the reflector.
I used PETG, due to better durability and uv/water resistance with i believe it was 20% infill.
Can be printed without support, however supports might be benefitial on the bottom side and the screw holes, depending on the accuracy of the printer.
These clamps don't have a hinge, so to attach them i simply unscrewed the vertical aluminium tube and put the clamps on, while spreading them a little with a screwdriver. Therefore the clamps sit tight and don't slip out of place. I use them for a while now and they still going good.
If you want to relocate your lights, you can use the screw and the nut from the light/reflector otherwise use m4 or m5 screws, the hole has a designed diameter of 6mm, depending on your printer the hole will be about 5.75 mm in diameter.
On side has a wider cutout then the other side, so that wider nuts often used on bikes fit.