Simplified Miniature Blast Furnace Of "Alto Horno Núm. 1"
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.42 – €2.96 net (excluding VAT)
For file: CE3PRO_Alto horno n1 simplificado a escala.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.69 excluding VAT (range midpoint).
- Weight reported by the author
- 19 g
- Print time reported by the author
- 3.4 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A simplified blast furnace miniature model at 1:1000 scale
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 76
- Makes
- 0
- Views
- 262
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Architecture & Urbanism
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
As the summary says, this is a simplified miniature of a blast furnace. I designed it for a city model in which I collaborated.
More specifically, the model is based on the “Alto Horno Núm. 1” in Sestao, Bizkaia located in Spain at the following coordinates:
43°18'41.8"N 3°00'01.7"W
https://maps.app.goo.gl/gpYVhRy9LhN32LDA8
In the last image of the post you can see the actual structure.
The model is approximately 1:1000 scale. These are its most relevant dimensions:


As is obvious, it is a very simplified model due to the complexity of the real structure and the scale at which I was trying to model it.
Print settings
Printed in PLA, without rafts, with manual supports, at 0.2 mm resolution and 15% infill.
To facilitate printing, you can activate the “Make Overhang Printable” option in Cura and set it to about 70.0°.
In addition, you can also use the “Custom Supports Cylinder” plugin to add manual supports instead of using Cura's automatic ones. You can place them in strategic locations such as suspended walkways.
With these settings your sliced model should look something like this:

Post-Printing
Once the model ins printed just remove the supports. It can be a bit tricky, so I recomend an small pointy object, like a screw driver, to remove the more intricate ones.