IKEA Malm Headboard (41mm) CPAP hose holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed to better fit my IKEA Malm headboard's depth. Added extra thickness to prevent legs releasing.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 152
- Makes
- 2
- Views
- 794
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My IKEA Malm headboard is thinner by almost 1cm than the original model. I had printed a block to shim it to fit for the 1st CPAP user but the grip diminished over time as the PLA crept under the stress. Eventually, I taped the holder in place so the holder still worked but I wasn't happy with how it looked up close.
When we added a 2nd CPAP user, it was time for an overhaul. I reduced the depth of the bridge to be close to the thickness of the headboard plus a 3M Command strip. I added a sloped run-off from the hook opening to the rear leg to brace against stress creep. I filleted most of the edges to make the hook smooth to the touch.
The holder should be printed on its side and requires a brim to get good bed adhesion due to the fillets.
I installed the holder with a 3M Command Strip on the rear leg so that it's hidden when installed and it prevents the holder from sliding laterally on the headboard.