THE (Screw) FILTER
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Under-bed Voron 2.4 air filter/bed fan combination. Remixed to remove the need for risky magnetic connectors.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 125
- Makes
- 5
- Views
- 958
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
THE (Screw) FILTER
Based on nateb16's excellent design (Printables, GitHub)
Want side fans attached the same way? Check out blankhaus' work.
This remix removes the need for the magnetic connector and allows for direct connection to the front frame rails.
Now includes modified FYSETC 3-fan variation!
Why Remix?
The magnetic connectors used to attach THE FILTER to the Voron are not readily available. Additionally, they are known to cause damage with intermittent short-circuits on connection/disconnection.
Unfortunately, these connectors are used to attach the filter to the frame. This remix adds mounting holes to the rear of the housing as an alternative mounting method.
Installation:
2x 25mm M3 fasteners (SHCS, BHCS, etc.) for mounting.
2x extrusion mounting hardware (M3 T-Nut, Hammerhead nut, etc.)
Note that since the magnetic connector is no longer used, you will need to utilize your own connector to attach the fan. Ensure that the wiring for this connector is long enough to be pulled to the front to connect/disconnect when removing or installing THE (Screw) FILTER.
Appreciate our (re)engineering?
Check out our masterpiece - the Tick Tock CircleClock!
IMPORTANT:
Please be careful when working around your bed heater, especially if it has mains voltage.
This design is provided “AS IS” without warranty of any kind, either expressed or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.