AppleTV Remote and AirTag
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tired of losing my AppleTV Remote - remote holder with an AirTag pocket
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
We have a habit of losing our appletv remote and we got sick of it. I've been struggling with a design, but this finally came out of my cranium.
This is printed from Amazon Basics TPU. So not the most amazing stuff, but it does the job.
You slide one side of the airtag under one of the “straps” and then use something thin to pull aside the second one.
The airtag is held tight and not allowed to rattle around. I figured it might scratch the bottom of the remote even if it was flipped over.
The front is flexible enough, just pull it down and then slide the remote rear end first. Pull the front back into place and it should almost snap into place.
I printed this with
Infill: 15% - gyroid
walls: 2