Keychain Hooks for HSW - 4 Sizes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For vending keychains, compatible with the HSW system.
- Rating
- 5 / 5
- Likes
- 151
- Downloads
- 776
- Makes
- 8
- Views
- 1,659
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Introduction
Hooks for storing multiple keychains or key rings. The notches stop the keychains from sliding around, and are spaced 10mm apart. The 30mm hooks have 3 notches, 60mm hooks have 6 notches, etc.
Designed to fit onto HSW (Honeycomb Storage Wall) boards. The display stand, if you were wondering, is here and a smaller one is here.
As usual, these are designed with no screws, no glue, no supports, no bridges and easy overhangs.
Material
- Suggest PLA, ASA, ABS, PETG-CF or similar stiffness materials.
- If you use PETG, the clip will be a little too easy to remove and
- If you use a stiff material like ASA-CF or ABS-GF, the clip will be difficult to insert/remove.
Print settings
- 2+ perimeters
- I suggest slowing down the outer walls to ensure the part comes out strong with consistent gloss level all around (but this is optional).
- This is a fairly easy print, everything else is up to you!
General precautions apply - ensure your build plate is clean (wash with hot water and dish soap and dry with a clean towel), add mouse-ears and/or apply some glue if you often have adhesion issues.
Support
If you would like to say thanks, please post a make and share here and on socials. You could buy me a few metres of plastic on Ko-Fi otherwise, please post a make and check out my other HSW models in this collection. If you are using these stands as a part of your business and are finding it helpful, please consider buying this price label model to support more projects like this.
Remixes with significant changes are very welcome.