1 / 6
Arcs Full Box Organizer (w/ Leaders and Lore) v 1.3 — image 1
1 / 6

Arcs Full Box Organizer (w/ Leaders and Lore) v 1.3

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a complete organizer for retail version of Arcs, plus the Leaders and Lore expansion. (It is designed for the…

Rating
5 / 5
Likes
45
Downloads
408
Makes
4
Views
2,486
Reviews
3

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

V1.3 - Per feedback, I've added an alternate version of the player tray with slightly thinner walls. If the tolerance between the lid and the tray is too tight, use that instead.

V1.2 - Per feedback, I've widened the gaps on the resource token tray, to make the tokens easier to grab. The new file has replaced the old one.

V1.1 - I've added a box for rolling the dice, that sits on top of the resource token tray during transport.

This is a complete organizer for retail version of Arcs, plus the Leaders and Lore expansion. (It is designed for the wooden pieces.)

Each player gets their own token tray, and there's a central organizer for the resource tokens.

The card holders will work with sleeved cards, though you may need to spread out the bigger card sets between two holders.

The token box lid and base will likely need supports, as there are some overhangs - though you could try without if your bridging is good. I used tree supports and everything came out clean.

To pack, put the cards and resource tokens on the bottom layer, with two card spacers to hold everything tight. Then put the board, player boards and all rules in the middle, with the board spacer. Finally, put the player trays, token tray and dice tray on the top.

Everything will fit nicely and the box should sit flush!

Print Settings

Printer Brand:

Bambulabs

Printer: 

Bambu P1S

**Supports:**

Yes

Resolution: 

Very fine for the player token lids, Normal for everything else

**Infill:**

15%

Filament: Inland PLA Various

 

 

Category: Games

Tags