LED bracket for Kotto fume extractor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
LED bracket for Kotto fume extractor
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 20
- Makes
- 0
- Views
- 206
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This design uses an LED board salvaged from an extra aftermarket car light I had. This light can be bought for around $5 off aliexpress. The listing I bought the light from has disappeared, but this looks like the same thing. Any light with the same 6 x 3 LED arrangement should do.
The fume extractor used is this one from amazon.
Installation is straightforward. After disassembling the light I soldered on some standard dupont style headers, but you can do whatever you want. Just get a couple cables attached to the light (polarity doesn't matter), run them down the tube, and you can easily reach 12V and ground on the PCB inside the extractor. Look for the cables coming from the barrel jack and solder your LED wires to those where they meet the PCB. Cut a small section out of the edge of the cardboard spacer piece to give the cables room to come through.
I would suggest securing the LEDs to the bracket with hot glue and securing the bracket to the fume extractor with CA glue, though it isn't required.