Apple Keyboard + TrackPad holder (2 part variant)

Apple Keyboard with number block and TouchID + TrackPad holder to keep the 2 devices together as one. Should fit the current devices well. =)

The 2 parts are screwed together with the M3 screws and the connector plate.

Super simple print! =)

Video:

Notes:

• The 3 part variant can be found here for smaller printers.
• Adjusting this to keyboards without the number block should be possible too.
• Printed on the Sovol SV08 as shown in 3 parts in 1 print session.
• You can add rubber feet to the bottom. You will find round 12mm cutouts.
• Cutouts for the nuts and screws should make connecting the pieces easy.
• Will work for left or right hand use because of the flat design. =)

Printing instructions:

• No supports needed
• Using a brim was not needed in my tests, because I cleaned my textured sheet with dishwashing liquid carefully with a new sponge and then with isopropanol alcohol again on the printer to make the parts stick really good. If you face problems with adhesion feel free to add a 5mm brim to the parts.
• 0.2 speed profile used.
• Textured sheet used:
  • If you use a textured sheet too, let it cool down completely after the print and wait for the part gets loose by itself. Do not pull on it to avoid ripping off the letters! 
  • In my case it takes 45-90 minutes after the print has ended and the part just lays loose on the print bed.
  • Do not touch the print bed and clean it with Isopropanol alcohol before printing.

Parts needed:

• 16x M3x6 screws
• 16x M3 nuts

Happy printing =)