Navimow i series garage

This is a simple garage for the Segway navimow robot lawnmower. The construction is based on 25mm (1") diameter water pipes and 4-5mm thick polycarbonate multiwall sheet. You will also need about 16 M4*35 screws, ideally with a decorative head. The roof pitch is 15 degrees. The polycarbonate is sprayed with coloured acrylic spray on the underside, and where there is a signal diode at the base, a window is masked with masking tape to make the panel transparent at that point. In my case, the board measures 65x100cm, but you can choose your own dimensions. It is a good idea to tape the cut edge with silver tape to prevent moisture from penetrating the cover plate.

For printing I recommend 3 perimeters and a layer height of 0.15mm, a higher layer may cause deformation of the round parts.  Everything can be printed without support and the parts are oriented correctly.