Herman Ohme Chess Magnet Tactile Set

Each figure has a greater weight according to its rank and make the game very pleasant. Each square has a magnet inside, this adds tactile effect also.

For print, I used matte PLA filament with fuzzy skin print style and my old friend Anet A6. 

You need other details and tools also. Like a metal stud bolt, I bought long stud and cut with my Dremel. Plexiglass I ordered by internet and leather too.

All squares were glued to plexiglass. You can also glue artificial leather to the bottom of the board if you wish. I did this) and was added print label of chess design author.

Important! The threaded rod should fit freely into the hex nut without screwing in. It is needed for additional weight of the game figure and its strength.

First, insert the required number of hex nuts into the figure, then screw the threaded rod into the figure.

Before, make a groove in the threaded rod for screw driver. Recommended lubricate everything with glue for additional fixation.

To pity I have not fixed the length of the spindles for each type of figure. I think you can easily measure after printing.

We created with my friend, special tool model to cut circles from leather. You can use part of blade office knife and the pin.