1 inch male adapter to 1 inch garden system G.F. BIG quick coupler
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€3.39 – €4.14 net (excluding VAT)
For file: GF1_vnejsi_zavit_0.1mm_PETG_MINI_4h44m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.77 excluding VAT (range midpoint).
- Weight reported by the author
- 29 g
- Print time reported by the author
- 4.73 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
1" adaptér s vnějším závitem do 1" rychlospojky zahradního systému G.F. BIG
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 84
- Makes
- 0
- Views
- 317
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
EN:
Adapter is used to connect the Quick Coupling of the Garden System G.F. BIG s.r.l. (Italy) to the standard 1-inch thread of the Garden Pump. I used Teflon tape to seal the thread and a 22.5 x 2.5 mm rubber O-ring for the quick coupler.
Recommended print settings:
- 0.1 mm layer height
- switch on the "long bridges" function
- 5 - 8 perimeters (due to long bridges and overhangs)
- switch internal seam position to “random” and "graduated (for better waterproofing)
- filling 100% (straightforward)
- supports are not needed (when using at least 5 perimeters or more and keeping the print in the position in which the 3D model is created)
CZ:
Adaptér slouží k připojení rychlospojky zahradního systému G.F. BIG s.r.l. (Italy) na standardní 1" závit zahradního čerpadla. K utěsnění závitu jsem použil teflonovou pásku a na rychlospojku jsem použil gumový O-kroužek o rozměru 22,5 x 2,5 mm.
Doporučené nastavení tisku:
- výška vrstvy 0,1 mm
- zapnout funkci "dlouhé mosty"
- 5 - 8 perimetrů (kvůli dlouhým mostům a převisům)
- přepnout vnitřní švy na pozici "náhodná" a na “odstupňované” (kvůli lepší vodotěsnosti)
- výplň 100% (přímočará)
- podpěry nejsou potřeba (pokud použijete 5 nebo více perimetrů a dodržíte takovou tiskovou polohu, ve které je 3D model vytvořen)