1 / 1
Asus PG279Q Power Brick Holder Bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A bracket to mount the power supply of an Asus PG279Q monitor to the underside of your desk.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 14
- Makes
- 0
- Views
- 95
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A bracket to mount the power supply of an Asus PG279Q monitor to the underside of your desk for better cable management. I would recommend printing this in something that is more heat resistant than PLA, since the brick does get slightly warm.
Step 1: Install four heat-set-inserts M3 into the base.
Step 2: Screw the base to the underside of your desk with wood screws.
Step 3: Insert power brick and install the cap with four screws M3x8mm.
BOM:
4x heat-set insert M3
4x countersunk wood screw 3x12mm
4x screw M3x8mm