Meta Quest 3 Koss KSC 75 Headphone Mount for BOBAVR S3 and others
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a over the ear headphone mount for the Koss KSC75 to be installed on the Meta Quest 3.
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 135
- Makes
- 1
- Views
- 1,145
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a modification of https://www.printables.com/model/705535-vr-koss-porta-mount-quest-3 of the vr_koss_mount part to allow it to accept the Koss KSC 75 headphones as well as increase the strength. In addition I reworked the MK2 mount to be as thin as possible as its width interferes with the ratcheting mechanism of some of the Head Straps
This will significantly increase audio quality and significantly reduce audio bleed out.
I also recommend replacing all M3 Nuts with Nylock M3 Nuts.
.IPT of the modified part is attached if anyone would like to modify it.
Part prints and works fine in PETG.
1. Print and Assemble design per VR-Koss_porta-mount-quest-3 instructions and replace the VR_Koss_mounts with VR_Koss_Mount KSC75. You will need M3 screws and nuts.
2. Buy a Koss KSC 75
3. Pop off over ear retainers off KSC 75
4. Pop on the KSC75 onto each of the VR_Koss_Mount KSC75. and verify left and right year.
5. Route wiring along headset and zip tie as necessary. Audio jack on the Meta Quest is on the ride side of the headset opposite of the charging port.