1 / 8
SUP/board/kayak propeller - Compact water pusher
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Push anything on the water: SUP, kayak, boat, board etc. Very compact, yet quite powerfull. Contains 70mm pump jet
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 53
- Makes
- 0
- Views
- 2,373
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
Dimensions without nozzle: 350x220x130 (still can be printed on 200x200 envelope - cover was cut printing)
Power: up to 2000W (with cooling)
Battery capacity: up to 150 Wh
Bill of materials - refer to the pictures
- Print all the parts (1x)
- Laser cut dxf parts
Seal - rubber (optional, you can create your own seal)
Flange - plastic
Plate - aluminum or plastic
Cover - plastic transparent (ex. PMMA - acrylic glass) - Assemble according to the pictures
- Cover all the body around by liquid sealant
- Connect electronics. Wires at least 12 AWG thick. Check the temperature inside often. Batteries, motor and ESC may get hot. Water cooling for power more than 300W is requred. In my setting I used two 4S batteries in series (no paraller!), 6S lipo or 18V dewalt battery. All of them were fine, i just had different speeds due to different voltages.