South Bend Lathe 13" Tailstock DRO Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows the use of a 6" digital caliper as a tailstock DRO on 1970's South Bend 13" lathe.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 47
- Makes
- 0
- Views
- 386
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Two part bracket allowing you to use a digital caliper as tailstock DRO on 1970's South Bend 13" lathe. Design was based on using an iGaging IP54 6" caliper, but could be modified to accommodate other brands.
I used PLA at 0.2 layer height, 75% infill on the large bracket, and solid fill for the quill clamp, but it would probably work fine with lessor infills.
The two cap screws on the quill clamp are both M4-0.7.
The large bracket slides/clips onto the body of the tailstock, and there is a pin in the bracket that fits in the dauber hole of the tailstock, preventing the bracket from sliding back and forth.
The caliper body slides into the bracket, and is held in place by the locking thumbscrew from the caliper. I used a cutoff wheel to remove the caliper jaws and shorten the depth rod. A single hole needs to be drilled in the end of the caliper slide to allow it to be attached quill clamp.