1 / 8
MJX Hyper Go 10208 shock lift
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A suspension lift mod for the MJX 10208 V1.1
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 304
- Makes
- 1
- Views
- 2,465
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Buy here: https://www.etsy.com/uk/listing/1876691283/mjx-hyper-go-10208-shock-lift
This mod dramatically increases the droop and suspension range by moving the mounting point up 8-11mm. There is no drive shaft binding.
ride height:
front = 58 mm (11mm version)
rear = 55 mm (11mm version)
Instructions:
- take note of the camber angle
- remove lower shock mounting bolts
- drill missing 3mm holes in stone shield
- install shock lift part + stone shield with 2 M3x16 screw
- reinstall shock with M3x16 screw and locknut
- adjust camber angle
BOM:
M3 locknut x4
M3x16 bolt x8 (+ original shock screws)
Print Settings:
Print individually
TPU 95A
5-8 parameters
60% infill