Working Headlights for 3ronco RC model

I created this because I was frustrated because my car had no front lights.

You will need:

• 2x 8 leds, WS2812B/5050 RGB rings DC5V (Black or White at your convenience)
• 1x  SP621E RGB controler
• 2x Dupont 1way connector
• 2x Female Dupont terminal 

Requirements:

• Clear PETG or PLA
• Black PETG or PLA

Print Settings:

• Supports: At your convenience
• CUTLight: 0.15 layerheight/2 walls/100% (very important)/ Colorchange at 2.6mm (First transparent and Black after).

STEPS:

• 1: Print the parts, put the rings on the supports, remove and put the new parts on the grille (pay attention to the ring cables orientation)
• 2: Cut the original connector on the SP621E, strip the cables, and crimp two Dupont female terminal on it, put them in their connector.
• 3: In your receiver, you can use a free channel, the -pin is on the right, and the positive in the middle.

At the moment I am not able to use the PWM signal, so when you turn on your car the lights turn on too. No control over the lights.