Headphone Wallmount/Deskmount holder - smallish

I wanted a small, deskmounted headphone holder, and couldnt find one that i liked.

So i made my own.
Made in Fusion 360, its 9cm deep (so should be enough to support the most headphones on the market), and 5cm wide (so it shouldnt leave marks even on the cushion of heavier headphones).

If your headset is a bit on the heavier side, i would put the wall count up to 4.
I printed with 3 and 15% gyroid infill, as my bt headset is rather light.

EDIT: The one printed in the photos is still version v1 with screwholes which were way too small. However that happened, the downloadable stl is fixed, with a screwholediameter of 5mm and a screwheaddiameter of 8mm!
And of course the part on the top is bigger (like you see in the screenshot out of my slicer).

Print instructions

Category: Audio Print Settings

Printer Brand: TEVO

Printer: Tornado

Rafts: No

Supports: No

Resolution: 0.28

Infill: 15%

Filament: Owl Filament PLA White
Notes:

Print time is about 1 hour @70mm/s general speed.

How I Designed This

Designed in Fusion 360 in about 30mins. Just put a basic sketch up, made it 90mm deep, and 50mm wide, and put some flesh onto the top and bottom, for screws on top and for stress relief a bit on the bottom.

Then i found out that i somehow got carried away and made the screwholes faaaar too small. So, what you see here is the revision, with normal sized screwholes.