Railed Pump Grip for Bug-a-Salt Gun
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two piece grip that uses the factory screws. Allows the use of any vertical grip that uses picatinny rails.
- Rating
- 4 / 5
- Likes
- 38
- Downloads
- 225
- Makes
- 0
- Views
- 2,703
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
Settings:
Print in orientation it loads in slicer.
4 walls.
50%+ infill.
Tree Supports with a support overhang angle of 45 degrees.
Raft is suggested but not required.
All other settings are personal preference.
Installation:
Remove the two philips screws from the original grip. The grip will come off in two halves. Orient the new grip so the angled slots are going the same direction as they ones on the gun(as seen in the pictures.) This grip only installs one direction. Attach to grip to pump studs, and screw back together using the factory screws. Attach desired grip.