1 / 3
superslim sliding glasslid clips for k1 max — image 1
1 / 3

superslim sliding glasslid clips for k1 max

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

superslim sliding glass cover for k1 max

Rating
0 / 5
Likes
6
Downloads
41
Makes
0
Views
317
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

i loved the model by ltek but it was very loose fitting and i wanted something sleeker so i remade it, this model raises the lid just about 1 mm enough to slide but not enough to stand out and it seals it  better and it's very tight fitting both for the glass and for attachment to the frame so the glass needs some force to move and i prefer to have it that way, i recommend printing one more and putting it at the front of the frame to stop the glass from sliding over the edge as the screws of the glass don't clear the front of the frame, these can be installed in different orientations i recommend printing 7 of them 3 on each side and one on the far edge such as the front to stop the glass from moving over the edge

i am in no way responsible for damage caused to your printer or to your glass lid, tempered glass is extremely unpredictable and have been known to explode during pressure or on it's own for no reason, use at your own risk, please note I made them pretty tight on the frame so you may have to break them in order to remove them and avoid harming the padding like i did, i may adjust this based on feedback and it's an stl so you can easily adjust it yourself

word of advise the frame is sensitive and if you hit the glass lid even lightly on the frame you'll cause a scratch

print laying down i used pla but i recommend something more heat resistant

Tags