Running Horse with support - easy to remove
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
.3mf-File. The support added will only be generated in PrusaSlicer.
- Rating
- 0 / 5
- Likes
- 29
- Downloads
- 170
- Makes
- 0
- Views
- 626
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The beautiful Running Horse by stronghero (a big compliment for the great design and many thanks you for providing it free of charge: https://www.thingiverse.com/thing:2438365 ) is not printable without support.
However, the support is not easy to attach if it is to be removed easily and without leaving any residue, so I had to experiment a bit. As the object is also quite fragile, especially when scaled down, I increased the number of walls to 3 and only created one wall for the organic support, as well as making a few other adjustments.
For a reasonably quick print (under 12 hours with the MK4, better without input shaper in this case!) I have attached a .3mf file scaled to 90 percent with 0.2 lh, see also the photo.
A 100 percent project file in 0.16 lh and a 60 percent version are also attached.
ATTENTION: The support will only be generated in PrusaSlicer.
I hope that my remix counteracts unnecessary waste of material due to failed test prints? My very small personal contribution against wasting resources - good luck and enjoy it.