38mm to 29mm Motor Adaptor Rings - for High Power Model Rockets
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple, cheap, and very effective way to use 29mm motors in your 38mm MMT Rocket
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 42
- Makes
- 0
- Views
- 200
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Meet the cheapest, most effective motor adapter out there. This is an adapter to allow you to use 29mm motors in your 38mm MMT Rocket.
All you need is a 29mm motor tube sized appropriately for your motors
Print the end ring and as many main rings as you need, then epoxy them onto the motor tube. I have several of these and have used them on over two dozen high-power rocket flights.
Note: To make sure your motor won't go blasting out the back end, be sure to have a stop. If your tube is short enough, you can tape the motor to the adaptor on the FWD end, or tape the motor to the AFT end. Your motor retainer's orifice may be small enough to keep the motor tucked away. If you would like, I can add a ring that goes between the motor and the retainer ring.