Firewalla Purple 10 Inch Rack Mount

This is designed to house a Firewalla Purple within 1RU in a 10-inch comms cabinet or minilab rack. There are no screws or anything required beyond what you use to bolt it into the rack, the Firewalla will press-fit into the cage and will stay in there snug enough to handle cables being plugged and unplugged. No need to remove the little rubber feet either.

There are two keystone holes too, up to you how you wish to use those (I chose to use one for a Cat6 pass-thru for incoming internet, and then I got lazy and just fed the power through the other). When I get a moment I might update this page with a blank with a notch to fit the power cable into to tidy it up some.

If you would like a variation of this design, feel free to reach out.

• Printed as you see in the pictures with black eSUN PLA+, if your rack runs hot then maybe consider PETG instead.
• This will print face-down diagonally on the buildplate of an Ender 3.
• Recommend 15-20% infill. Purples are not very heavy.

There are sliiiight overhangs on the back side of the Firewalla cage, from memory I did print with supports on, from off the buildplate just for that inside area.

Update 15-4-25 - Uploaded V2 which has revised screw hole locations.